Skip to content Skip to sidebar Skip to footer

How to stick ceramic tiles on a wooden base

The need for a sticker of ceramic tiles on a wooden surface does not arise very often. But, during the repair, or in the process of implementing a particularly interesting design idea, such a task may arise.

Immediately make a reservation, sticker tiles directly on a board or beam is an extreme case, it is advisable to avoid it. The fact is that the tree “breathes”, the width of the wooden board (timber) is very much dependent on air humidity. In addition, newly built wooden structures eventually give a shrinkage (for walls – 5 cm per meter of height). Therefore, it is much better to use a plywood base for tiles.

The use of plywood foundation in the sticker of ceramic tiles

As just noted above, the tree is a very “living”, “mobile” material. As a result, glued tiles can fall off, or crack. Therefore, it is always better to use a plywood base. In comparison with natural wood, plywood is very poorly deformed when humidity changes.

Further you can not continue – the technology of gluing tiles on Fanerunich does not differ from installation on any other grounds. It is only necessary to use a special glue. All large manufacturers in the line of adhesive compounds for tiles include adhesives for installation on plywood, chipboard, fiberboard, etc. p.

The best option is the screed device

How to stick ceramic tiles

This option is not suitable for all cases, mainly for laying tiles on the floor. But it gives one hundred percent guarantee of the reliability of the tile coating. It is best to completely dismantle the wooden floor, fill with expense with expanded clay, make a screed and lay tiles on the screed. True, it is more complicated and more expensive.

Glue “liquid nails”

“Liquid nails” are used to stick tiles directly on a wooden surface. This is a universal glue for gluing wooden materials from wood.

The wooden surface must be pre -prepared. It is necessary to remove all the pollution from it, to rummage to smooth out irregularities, cleaned with dust with a clean rag or brush and degrease. Ceramic tiles – heavy item for stickers on the wall. Therefore, glue should be applied with a snake, according to the instructions on the packaging. The time of complete drying of such glue is from 12 to 24 hours. The drying time depends on the temperature and humidity in the room as well as on the thickness of the applied layer of glue.

“Liquid nails” guarantee a strong connection of wood products, plywood, chipboard, gypsum and drywall, metal and ceramics.

On our site you can:

Also on the site: