Installing the front door is a task that almost any person can cope with which. However, you need to carefully prepare for this, you can read the instructions on the site . Initially, you need to collect the tools that will be required in this matter.
Tools
For installation, you will need:
Bulgarian.
Perforator (drill).
Roulette (ruler).
Level.
Saw.
Hammer.
As for consumables, you need to prepare wooden planks, mounting foams, metal rods or anchors in advance (their diameter should be approximately ten to twelve millimeters).
Preparation of the opening
First of all, from the opening it is necessary to remove cement and plaster. This will provide an opportunity to get to masonry without any problems. Secondly, he is driven under the purchased door. Thus, the opening can be narrowed or expanded.
Only after that the box is installed. It is recommended to remove the doors from her in advance. This will greatly simplify the work. The box is fixed using wooden wedges.
In areas of fixing the frame to the wall, holes designed for anchor bolts are made. They need to tighten them as tightly as possible. It is worth noting that instead of bolts you can use metal pins. They are additionally recommended to weld to the box. However, this decision can be abandoned due to its complexity.
After that, you can carefully check the accuracy of installing the box using the construction level and finally tighten the bolts. If the canvas was installed without accessories, then at this stage you can start installing the lock, fastening the loops and installing the handles.
Ending of work
At this stage, the door is hung on loops. It is recommended to do this with an assistant, given the impressive weight of the entire structure. Then the course of the canvas with the exposed fittings is checked.
The existing gaps between the door and the wall need to be filled with mounting foam. Additionally, you should secure the door frame from damage with painting tape.
In a wooden frame you need to put several spacers (at least three or four). Otherwise, there is a chance that the foam simply deforms the box during the drying process.
The foam is covered with the help. They are intended for finishing slopes. The work is completed by the installation of door platbands, which will add structures of greater aesthetics.
Photos of doors: