If you decide to make a quick and economical repair in the bathroom, then you should start with the dismantling of the ventilation hole. To do this, you need to turn off the wiring, and then the drain pipe. Break the bath from the place, then the ventilation pipe. After that, you will have to pay attention to the tile. It should also be removed from the place of stay using a chisel or a Fomka, along with a heavy hammer. By the way, the electronic document management program is now very popular to find out more about it, it will not be superfluous.
After that, it is worth starting the removal of paint from the walls. This is a complex lesson that should take a long time. In this case, it is worth immediately leaving the use of many chemicals, since they will not help properly, you need to use a punch with acute adjacent. This will take about ten days, if you spend about five hours of your time per day.
Then lay the tile to the floor. It is necessary to start work from the left far corner, gradually moving to the middle. Another step is wall repair. It is necessary to wash the plaster, and then start primed the caverns using a special repair mixture.
The primer of the walls should also not take much time, it is best to use a wide brush for this. The most difficult and long stage is the laying of tiles on the walls. It must be laid up from the bottom up, so it will be a little easier. The final finish takes little time. To do this, you need to glue plastic corners instead of a plinth. After the sink, bathroom (shower), ventilation grilles are installed.