If there is no way to connect to water supply on your site, then one of the alternative options would be a drilling of a well. How to do it on our own we will consider in this article.
The drilling of a well is the process of destruction of the rock with a specialized technique. With independent drilling, the drilling tool is screwed into the ground for a certain meter, and then stretches.
With independent drilling, there are a lot of undeniable advantages from which you can highlight:
Significantly less costs of materials will go;
Less cost of further maintenance;
You can either rent a drilling tool for drilling, or make it yourself.
Blaging technologies
There are currently several technologies for drilling wells:
Column – consists in immersing a hollow pipe in the ground, which moves along the spiral trajectory. The bottom of the pipe is equipped with a special “crown”, and when the pipe is completely immersed in the ground, a bar is attached to it, which helps to pass several tens of centimeters. This method of drilling is more suitable for unclean rocks;
Zheloning-drilling is performed using a special tin tool, which on the edge has a cutting-and-catching device. Due to a strong blow, the pipe is immersed in the ground, as if cutting it. Shock technology should consist of a tripod with a height of up to 2 meters. With the help of a cable that is missed through the block, the slaughter both drops and rises;
Swing drilling – using such drilling technology, water will be suitable only for watering. Screwing horizontally the screw destroys the breed, and when raising the slut is cleaned independently.
Drilling
In order to save, since the price of drilling wells is not small, using some manipulations, the drilling screw can be made of an unsuitable agricultural machine. Several pipes with rifled carvings are also needed.
Then it is necessary to convert the lower end into the screw. This can be done using two knives that are welded at an angle of 25 degrees. A threaded clutch is installed upstairs, which is hard to weld. Threaded clutch is necessary to screw the bar. Then it is necessary to weld the transverse handle on the guide bar, through which the screw will enter the ground.
After the completion of all manipulations, you can proceed to drill on the site.